Motorcycle Club Patches: Rockers, Centers & Sizing Guide | Global Patch Hub
Skip to content
Industry Guides

Motorcycle Club Patches: Rockers, Center Patches and Sizing

How motorcycle club patch sets are laid out, what each piece means, the sizes that fit a vest, and how to have them made and attached.

By Global Patch Hub Team · · 3 min read

In motorcycle culture, the layout of the back patch, the words on the rockers and even the small tabs carry meaning. If you're starting a club or redoing your colors, it helps to understand the conventions before you design anything.

The parts of a club back patch

A traditional club back patch is made of several separate pieces:

  • The top rocker is an arched strip across the shoulders with the club name.
  • The center patch is the club's logo or emblem, in the middle of the back.
  • The bottom rocker is an arched strip below the center, usually showing a location such as a city, region or state.
  • The MC tab is a small rectangle, normally beside the center patch.

Making them as separate pieces is part of the tradition, and it's practical too. A member's bottom rocker can change if they move to another chapter without replacing the whole set.

Riding clubs and the three-piece layout

In many regions, the full three-piece layout with an MC tab is associated with established motorcycle clubs, and wearing a territory on a bottom rocker can be a sensitive issue. That's why a lot of riding clubs, charity rides and riding groups use a one-piece back patch or a top rocker only. If you're forming a new club, it's worth learning the local customs before choosing a layout. We make whatever design you approve, but we'd rather you know about this before the patches arrive.

Sizes that fit a vest

Back patches are large. A center patch is commonly 10 to 12 inches wide, and rockers run roughly 12 to 14 inches across, sized to follow the curve of the center patch. Measure the back of an actual vest from seam to seam before settling on a size, since vests vary a lot, especially between sizes S and 3XL.

Front patches are smaller. Typical ones include:

  • Name or road name patches, often 3.5 to 4 inches wide
  • Officer patches such as President, Vice President, Road Captain or Secretary
  • Small versions of the club logo for the chest
  • Memorial, rally and charity ride patches

Name patches can be made as one design with a different name on each piece, and all of them count toward the 10-piece minimum.

Embroidered is the standard

Club colors are almost always embroidered. The raised texture and merrowed or cut edges hold up to wind, sun and years of riding. Polyester thread resists fading better than rayon, which matters for a vest that spends its life outdoors. For rockers, a cut border that follows the arch gives the cleanest edge. If your logo has a lot of small detail, we may suggest simplifying parts of it so it stays sharp at vest size.

Attaching patches to a leather vest

Sew-on is the only real option for club colors. Iron-on adhesive doesn't bond to leather, and heat can damage the vest. Most riders take a full set to a leather shop or tailor with a heavy-duty machine, which gives a clean, even stitch line and keeps the rockers aligned. Hand sewing is possible with a leather needle and heavy thread, but expect it to take a while.

Line up the center patch first, then position the rockers with an even gap above and below. Pin or tape everything in place and check it with the vest on before any stitching.

Your design, your colors

Club logos are often protected by their owners. We only produce club patches for the club that owns the design, or for people with the club's permission. Original logos for new clubs are welcome, and our designers can help turn a sketch into embroidery-ready artwork. Our guide to preparing artwork for embroidery explains what to send.

Ordering a full set

When you request a quote, list each piece separately: center patch, top rocker, bottom rocker, tab, and any front patches. Include sizes, colors and quantities. You'll see a proof of the whole set before production. For more examples, visit our motorcycle club patches page.

Keep reading

Ready to bring your patch idea to life?

Tell us about your design and get a free, no-obligation quote. Minimum order is just 10 patches per design.